Projects

There are 6 results.

open4aviation

AQUASENSE - Research and Validation of a Prototype for Simultaneous LWC/IWC Detection in Icing Wind Tunnels

Within the AquaSense framework, a method for the simultaneous detection of both the aggregation state and concentration of water in flowing media, specifically for application in high temporal resolution icing wind tunnels, will be investigated for the first time in order to test, optimise and certify aircraft systems under defined icing conditions. A photoacoustic spectroscopy based prototype will be developed and tested under different operating conditions in the RTA Icing Wind Tunnel and the FHJ Icing Wind Tunnel.

open4aviation

IceDrip - Aircraft Anti-icing and De-icing through Assemblies of Conducting Varnish and Functional Coatings

In the project IceDrip the rather promising concept of a discontinuous, electro-thermal de-icer is being investigated. The main aim of the present project is to significantly increase the already existing energetic advantages of the discontinuous de-icer by means of surface-active coatings, in order to achieve a performance range which would make the system suitable for general aviation aircraft, as well as smaller aircraft, which are equipped as large aircraft.

open4aviation

MIXVAL - Mixer Simulation and Validation

In passenger aircraft, the mixing and distribution of humid airflow from the cabin and engines into the cockpit and passenger cabin, as well as electronic components, takes place at a central location of the air conditioning system, the mixer. So far, the flow and heat transfer processes and the ice formation and accretion cannot be calculated with sufficient accuracy. Therefore, the aim of this project is to develop a method for simulating the physical processes in the mixer.

open4aviation

TWID - Heating-Paint Sensor Based Wing Ice Detector

In the scope of the TWID project, a method for reliable detection of ice on wing surfaces and other relevant structures on an aircraft is to be developed, examined and validated in the course of various tests on the small-scale and full-scale models in the icing wind tunnel. Ice detection combined with the de-icing method, which is already in development, results in a completely self-sufficient de-icing system, which independently identifies and reliably removes ice on the wings.

open4aviation

VertSLD - Prospecting for the Construction of a Vertical Icing Wind Tunnel for Experimental Simulation of Icing by Supercooled Large Droplets

The exploratory project VertSLD investigates both the physical feasibility and economic viability of an icing wind tunnel concept which avoids many of the difficulties that arise in existing icing wind tunnels when the size of the water droplets exceeds a few hundred microns. in this new concept the "flight path" of the drops within which they are supercooled is arranged vertically and not horizontally.

open4aviation

eWING_DE-ICER - Development of an Energy-Efficient Electrothermal De-icing System for Wing Leading Edges in Aviation

Within the scope of the eWING_DE-ICER project, a method for developing energy-optimised de-icing systems for wing leading edges, based on a thermoelectric heating system, is to be developed. In addition to the development of forecasting models for the optimal design of all components involved, different prototypes are to be set up as in the model, as well as in full-scale, and tested in various icing wind tunnels.