Projects
There are 7 results.
Aviation Icing Tests IV - Cloud Generation for Realistic Icing Tests on Aircraft Components, With and Without De-Icing or Anti-Icing Facilities
this research project will examine consequent research topics with a focus on increasing the LWC (Liquid Water Content) for Appendix C as well as the distribution and reduction of the LWC for Supercooled Large Drops (SLD). It is building on research projects Aviation Icing Tests, Aviation Icing Tests II and Aviation Icing Tests III that have already been carried out.
FSA - Future Small Aircraft
The aim of this funded project is to launch a modern and highly efficient "Future Small Aircraft" in the general aviation category, which will reduce operating costs to a minimum and thus meet the growing demand. The end result of this project is a certifiable prototype, which will be developed in a timeframe of around 32 months.
ICE GENESIS - Creating the Next Generation of 3D Simulation Means for Icing
The top level objective of the ICE GENESIS project is to provide the European aeronautical industry with a validated new generation of 3D icing engineering tools (numerical simulation and test capabilities), addressing App C, O and snow conditions, for safe, efficient and cost effective design and certification of future aircraft and rotorcraft.
IceDrip - Aircraft Anti-icing and De-icing through Assemblies of Conducting Varnish and Functional Coatings
In the project IceDrip the rather promising concept of a discontinuous, electro-thermal de-icer is being investigated. The main aim of the present project is to significantly increase the already existing energetic advantages of the discontinuous de-icer by means of surface-active coatings, in order to achieve a performance range which would make the system suitable for general aviation aircraft, as well as smaller aircraft, which are equipped as large aircraft.
MIXVAL - Mixer Simulation and Validation
In passenger aircraft, the mixing and distribution of humid airflow from the cabin and engines into the cockpit and passenger cabin, as well as electronic components, takes place at a central location of the air conditioning system, the mixer. So far, the flow and heat transfer processes and the ice formation and accretion cannot be calculated with sufficient accuracy. Therefore, the aim of this project is to develop a method for simulating the physical processes in the mixer.
TWID - Heating-Paint Sensor Based Wing Ice Detector
In the scope of the TWID project, a method for reliable detection of ice on wing surfaces and other relevant structures on an aircraft is to be developed, examined and validated in the course of various tests on the small-scale and full-scale models in the icing wind tunnel. Ice detection combined with the de-icing method, which is already in development, results in a completely self-sufficient de-icing system, which independently identifies and reliably removes ice on the wings.
eWING_DE-ICER - Development of an Energy-Efficient Electrothermal De-icing System for Wing Leading Edges in Aviation
Within the scope of the eWING_DE-ICER project, a method for developing energy-optimised de-icing systems for wing leading edges, based on a thermoelectric heating system, is to be developed. In addition to the development of forecasting models for the optimal design of all components involved, different prototypes are to be set up as in the model, as well as in full-scale, and tested in various icing wind tunnels.