Projects
There are 5 results.
DJET - D-JET Concept
The goal of the D-Jet project is to construct a small jet for an emerging market segment with a significantly lower price-performance ratio than earlier business jets, better performance with regard to the cruising speed and the rate of climb, short runway requirements for takeoff and landing, as well as a total registered weight under 2,000 kilograms.
IceDrip - Aircraft Anti-icing and De-icing through Assemblies of Conducting Varnish and Functional Coatings
In the project IceDrip the rather promising concept of a discontinuous, electro-thermal de-icer is being investigated. The main aim of the present project is to significantly increase the already existing energetic advantages of the discontinuous de-icer by means of surface-active coatings, in order to achieve a performance range which would make the system suitable for general aviation aircraft, as well as smaller aircraft, which are equipped as large aircraft.
MIXVAL - Mixer Simulation and Validation
In passenger aircraft, the mixing and distribution of humid airflow from the cabin and engines into the cockpit and passenger cabin, as well as electronic components, takes place at a central location of the air conditioning system, the mixer. So far, the flow and heat transfer processes and the ice formation and accretion cannot be calculated with sufficient accuracy. Therefore, the aim of this project is to develop a method for simulating the physical processes in the mixer.
TWID - Heating-Paint Sensor Based Wing Ice Detector
In the scope of the TWID project, a method for reliable detection of ice on wing surfaces and other relevant structures on an aircraft is to be developed, examined and validated in the course of various tests on the small-scale and full-scale models in the icing wind tunnel. Ice detection combined with the de-icing method, which is already in development, results in a completely self-sufficient de-icing system, which independently identifies and reliably removes ice on the wings.
eWING_DE-ICER - Development of an Energy-Efficient Electrothermal De-icing System for Wing Leading Edges in Aviation
Within the scope of the eWING_DE-ICER project, a method for developing energy-optimised de-icing systems for wing leading edges, based on a thermoelectric heating system, is to be developed. In addition to the development of forecasting models for the optimal design of all components involved, different prototypes are to be set up as in the model, as well as in full-scale, and tested in various icing wind tunnels.