Projects

There are 4 results.

open4aviation

IceDrip - Aircraft Anti-icing and De-icing through Assemblies of Conducting Varnish and Functional Coatings

In the project IceDrip the rather promising concept of a discontinuous, electro-thermal de-icer is being investigated. The main aim of the present project is to significantly increase the already existing energetic advantages of the discontinuous de-icer by means of surface-active coatings, in order to achieve a performance range which would make the system suitable for general aviation aircraft, as well as smaller aircraft, which are equipped as large aircraft.

open4aviation

TWID - Heating-Paint Sensor Based Wing Ice Detector

In the scope of the TWID project, a method for reliable detection of ice on wing surfaces and other relevant structures on an aircraft is to be developed, examined and validated in the course of various tests on the small-scale and full-scale models in the icing wind tunnel. Ice detection combined with the de-icing method, which is already in development, results in a completely self-sufficient de-icing system, which independently identifies and reliably removes ice on the wings.

open4aviation

eSAFE - Emergency Safe Return for CS23 Aircraft

The aim of the project is the development of an automatic emergency flight guidance, including emergency landing for the EASA CS23 category aircraft. In case of sudden in-flight pilot incapacitation or technical problems, after activating the emergency button on board, an airfield with an approach route taking into account dynamic air traffic and weather data should be determined.

open4aviation

eWING_DE-ICER - Development of an Energy-Efficient Electrothermal De-icing System for Wing Leading Edges in Aviation

Within the scope of the eWING_DE-ICER project, a method for developing energy-optimised de-icing systems for wing leading edges, based on a thermoelectric heating system, is to be developed. In addition to the development of forecasting models for the optimal design of all components involved, different prototypes are to be set up as in the model, as well as in full-scale, and tested in various icing wind tunnels.